This guest post is authored by Ned Espy, technical director at Beamex. This post was written in conjunction with an ISA co-hosted webinar on differential pressure flowmeter calibration. This is Part 1 of the two-part ISA webinar series. To watch the webinar recording for Part 2, click this link.
For flowmeter calibration, the phenomenon of “low flow cut-off” is only associated with differential pressure transmitters with square root extraction—if the square root (flow) calculation is done in the control system (DCS/PLC), then this test approach does not apply. The graphic below illustrates the issue.
Some may ask why we are testing the initial point at 10 percent and may be concerned that we are not measuring the first 10 percent of flow. Note in the graphic above how rapidly the output flow signal (mA) changes with a very small change in the differential pressure input. For testing such a transmitter, the first 10 percent of flow cannot be used to meter the process because it is unstable, unpredictable and vendors filter that portion of the signal.
In demonstrating how to test and trim a DP transmitter, our first test point was actually at 1 percent of the input (DP) which represents 10 percent of the output (flow). When the signal is below this value, it is usually converted to zero by the control system because it jumps around too much. The graphic below displays recommended example test points and a graph of actual test data.
If your application requires accurate metering below 5.6 mA (less than 1 percent of the differential pressure, which is less than 10 percent of the flow rate), then you will need a secondary meter with a lower range (for example, 0 to 30 in H2O would complement a 0 to 207 in H2O range).
To watch the webinar recording for Part 2, click this link.
Blog Posts
How Often Do Measurements Need to Be Calibrated?
Just in Time, or Just Too Late? A Kaizen Approach to Calibration
How to Improve Industrial Productivity with Loop Calibration
Temperature Calibration: Using a Dry Block to Calculate Total Uncertainty
How Can Advanced Calibration Strategies Improve Control Performance?
How to Calibrate a Pressure Transmitter
Webinar Recordings
Uncertainty in Calibration
Calibration Uncertainty and Why Technicians Need to Understand It
How to Avoid the Most Common Mistakes in Field Calibration
Learn Advanced Techniques in Field Calibration
How to Build an Industrial Calibration System Business Case
How to Use Calibration Tools for Accurate Process Temperature Measurement
How Does Low Flow Affect Differential Pressure Flowmeter Calibration?
Three Common Pitfalls of Pressure Calibration
Webinar Recording: How to Calibrate Differential Pressure Flowmeters
Free Downloads
ISA Industrial Calibration Worksheets
Measurement Uncertainty Analysis Excel template plus book excerpt
Calibration Handbook of Measuring Instruments book excerpt
In-Depth Guide to Calibration for the Process Industries eBook
Calibration Uncertainty for Non-Mathematicians white paper
About the Presenter
Ned Espy has been promoting calibration management with Beamex for more than 20 years. He has directed field experience in instrumentation measurement application for over 27 years. Today, Ned provides technical & application support to Beamex clients and partners throughout North America.